The fresher the butyl spacer, the better, that is, the best to use just produced, if the butyl spacer is stored for too long, the use of the butyl spacer needs to focus on the heating of the glass, otherwise the bonding force is not enough, which will cause installation failure and air leakage. So how do you use butyl spacers? How do you seal them?

First of all, use heating equipment to heat the glass, place the butyl spacer at a distance of 2-5 mm from the edge of the glass, put it smoothly, heat another piece of glass and place it on the top of the code of the butyl spacer bar, and the glass below it, gently press the edge of the glass, so that the butyl spacer glue and the glass are fully combined, and then heat. Butyl spacer is installed.

When we install the final sealing part of the butyl spacer bar, we only need to align one end of the butyl spacer bar with the other end, and the gap is controlled within 1 mm. When the glass is squeezed or heated, the gap here will be sealed, and there is no need to worry about the problem.

If you are worried about the installation of the butyl interval bar, you can extract the experiment, randomly extract one and place it in water, waiting for 24 hours, and then go to see that it is qualified without water.

This is the way of the process, you learned?